Clarion Ungo Pro Security SR1000, Installation Manual

Page: 23 / 55

23
H2/4 VIOLET/BLACK channel 4 output
This wire provides 200 mA programmable output. (See Feature Descriptions section of this guide.)
IIM MPPO ORRTTA AN NTT!! Never use this wire to drive anything but a relay or a low-current input! This transistorized output
can only supply 200 mA, and connecting directly to a solenoid, motor, or other high-current device will cause
the module to fail.
H2/5 WHITE/BLACK channel 5 output
This wire provides 200 mA programmable output. (See Feature Descriptions section of this guide.)
IIM MPPO ORRTTA AN NTT!! Never use this wire to drive anything but a relay or a low-current input! This transistorized output
can only supply 200 mA, and connecting directly to a solenoid, motor, or other high-current device will cause
the module to fail.
relay satelite connecting to key switch
wire connection guide
The five heavy gauge wires coming from the large connector are used to energize high current cir-
cuits in the vehicle. It is crucial that these connections are well-made and capable of handling the
current demands. For this reason, Scotch-Locks, T-taps and other such connectors are strongly dis-
couraged.
PURPLE (+) starter output
After cutting the starter wire connect the PURPLE wire to the end going to the starter motor.
GREEN starter input
After cutting the starter wire connect the GREEN wire to the end going to the key side of the ignition.
RED (2) (+)12V input for high current outputs
Remove the two 30-amp fuses prior to connecting these wires and do not replace them until the satel-
lite has been plugged into the control module. These wires are the source of current for all the cir-
cuits the relay satellite will energize. They must be connected to a high current source. Since the fac-
tory supplies (+)12V to the key switch that is used to operate the motor, it is recommended that these
wires be connected there.
N NO OTTEE:: If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED wire of the
satellite to each feed at the switch.