Cisco RF Gateway 1 Modules, Configuration Manual

Page: 221 / 286

Steps To Take
78-4025112-01 Rev H0 197
Result: The entry is highlighted as shown in the following screen.
2 Click Apply to accept change or Reset to abort.
Descriptor Rule Parameters
The following table describes the Descriptor Rule parameters.
Parameter Description
Name Identification of the descriptor rule.
Type Allows you to select the rule type.

Add Private Data - add data to the standard descriptor.

Do Not Insert - prevents updating the CA descriptor in the PMT if
the PSI/SI information is generated by an external PSIG.
Notes:

If the rule type is set to Do Not Insert , the Insert and Private Data [Hex]
parameters are unavailable.

Private data is CA Vendor proprietary.
Insert Select the insertion level mode for the private data part.

According to EIS - EIS determines insertion level.

At ES Level - insertion is performed at ES level (even if service level
scrambling is defined by the EIS).
ECM ID(s) ECM ID(s) to which the CA descriptor rule must be applied. Multiple
IDs must be separated by a comma.
Private Data (Hex) Private data of the descriptor rule.
Notes:

The RFGW-1 adds a standard CA descriptor to the PMTs of scrambled services,
or elementary streams.

When no IDs are added into the Data ID(s) box, the descriptor rule is applied to
all ECMs. Since only one rule with empty Data ID(s) box is allowed, this rule
overrules the standard CA descriptor.

When IDs are added, the rule is only applied to the ECM IDs appearing in the
ECM ID(s) box. Only one rule can be effective for a certain ECM ID.

ECM IDs added must be unique over all descriptor rules for a certain ECMG.