Cisco RF Gateway 1 Modules, Configuration Manual

Page: 115 / 286

Provisioning
78-4025112-01 Rev H0 91
Result: The Advanced Settings window is displayed.
5 In the Source IP Address field, enter the source IP addresses you want your stream
to listen to.

The default ‘0.0.0.0’ implies don’t care.

1 is primary

2 is secondary

3 is tertiary

4 is quaternary
Note: If the device detects a stream which matches any of these three, it will pass
it through.
6 In the Ignore UDP Port field, select True or False.
Note: The Ignore UDP Port setting can potentially make the configuration of the
GbE network easier because only the multicast IP address must be provisioned
(i.e., remembered), but it assumes that only one stream on each multicast address
will be present. Thus, care must be taken to ensure each MPTS has its own
unique IP address. Failure to do this will result in problems such as over-
subscription and dejittering issues.
7 In the PCR PID Select field, the user can choose the following for MPTS streams:

From PMT

First detected