Cisco ONS 15454 SDH, Procedure Manual

Page: 176 / 860

6-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
Before You Begin
15.
NTP-D135 Test Low-Order Circuits, page 6-53 —Complete this procedure after you create an
electrical circuit.
16. NTP-D323 Create an Automatically Routed High-Order Circuit, page 6-55 —Complete as needed.
17.
NTP-D324 Create a Manually Routed High-Order Circuit, page 6-60 —Complete as needed.
18. NTP-D190 Create a Unidirectional High-Order Circuit with Multiple Drops, page 6-63 —Complete
as needed.
19.
NTP-D62 Test High-Order Circuits, page 6-66 —Complete this procedure after you create a
high-order optical circuit.
20. NTP-D139 Create a Half Circuit on an MS-SPRing or 1+1 Node, page 6-68 —Complete this
procedure as needed to create a half circuit using an STM-N as a destination in a multiplex
section-shared protection ring (MS-SPRing) or 1+1 protection.
21.
NTP-D140 Create a Half Circuit on an SNCP Ring Node, page 6-70 —Complete as needed to create
a half circuit using an STM-N as a destination in an subnetwork connection protection (SNCP) ring.
22. NTP-D191 Create an E-Series EtherSwitch Circuit (Multicard or Single-Card Mode), page
6-72
—Complete as needed.
23.
NTP-D192 Create a Circuit for an E-Series Card in Port-Mapped Mode, page 6-75 —Complete as
needed.
24. NTP-D142 Create an E-Series Shared Packet Ring Ethernet Circuit, page 6-77 —Complete as
needed.
25.
NTP-D143 Create an E-Series Hub-and-Spoke Ethernet Configuration, page 6-80 —Complete as
needed.
26. NTP-D144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect, page
6-82
—Complete as needed.
27.
NTP-D145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect, page
6-85
—Complete as needed.
28. NTP-D146 Test E-Series Circuits, page 6-89 —Complete this procedure after creating E-Series SDH
circuits.
29.
NTP-D148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode,
page 6-90
—Complete as needed.
30. NTP-D241 Provision G-Series Ports for Transponder Mode, page 6-92 —Complete as needed.
31.
NTP-D149 Test G-Series Circuits, page 6-95 —Complete this procedure after creating G-Series
SDH circuits.
32. NTP-D194 Create Overhead Circuits, page 6-96 —Complete as needed to create data
communications channel (DCC) tunnels, create IP-encapsulated tunnels, provision orderwire, or
create user data channel (UDC) circuits.
33.
NTP-D283 Create an Automatically Routed VCAT Circuit, page 6-97 —Complete as needed.
34. NTP-D284 Create a Manually Routed VCAT Circuit, page 6-101 —Complete as needed.
35.
NTP-D325 Create an STM Test Circuit around the Ring, page 6-103 —Complete as needed.
36. NTP-D350 Create a Server Trail, page 6-106 —Complete as needed.
Table 6-1 defines ONS 15454 SDH circuit creation terms and options.