Cisco ONS 15454 SDH, Procedure Manual

Page: 689 / 860

20-5
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D310 View Ethernet Trunk Utilization
The MAC address table information appears.
Step 4 Return to your originating procedure (NTP).
DLP-D310 View Ethernet Trunk Utilization
Step 1 In node view, click the Maintenance > Ether Bridge > Trunk Utilization tabs.
Step 2
Select the desired time interval in the Interval field.
Step 3 Click Refresh .
The trunk utilization information for the current and previous time intervals appears.
Step 4
Return to your originating procedure (NTP).
DLP-D311 Provision a Half Circuit Source and Destination on an MS-SPRing or
1+1 Node
Step 1
From the Node drop-down list, choose the node that will contain the half circuit.
Step 2 From the Slot drop-down list, choose the slot containing the card where the circuit will originate.
Step 3
From the Port drop-down list, choose the port where the circuit will originate. This field might not be
available, depending on the card chosen in
Step 2 .
Purpose This task changes the screen view to display the Ethernet Trunk
bandwidth usage on a selected card.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This task provisions a half circuit source and destination on an MS-SPRing
or 1+1 node. A half circuit allows you to provision a partial path (one end
of a circuit), for example, if you want to provision a circuit with the intent
that the path will be completed at a later time or at a different location.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
This task can only be performed as a part of the “NTP-D139 Create a Half
Circuit on an MS-SPRing or 1+1 Node” procedure on page 6-68 .
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher