21-49
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D493 Provision the Ethernet Port of the ML-Series Card
DLP-D493 Provision the Ethernet Port of the ML-Series Card
Step 1
In node view, double-click the ML-Series card where you want to provision the Ethernet port.
Step 2
Click the
Provisioning
>
Ether Ports
tabs.
The Ether Ports pane appears.
Step 3
In the Ether Ports pane complete the following:
•
Port—Displays a fixed number identifier for the specific port.
•
Port Name—Enter a 12 character alphanumeric identifier for the port.
Note
Circuit table displays port name of the POS port and not the Ethernet port.
•
Admin State—Displays the state of the port. Allowed values are UP and DOWN. For the UP value
to appear, the Ethernet port must be both administratively active and have a SONET/SDH circuit
provisioned.
•
PSAS (Pre Service Alarm Suppress)—Check the PSAS checkbox to enable alarm suppression on
the port for a time interval set in the Soak Time column. Uncheck the PSAS checkbox to disbale
alarm suppression.
•
Soak Time—Enter a desired soak time in hours and minutes (hh:mm) format. Use this column when
you have checked PSAS to suppress alarms. Once the port detects a signal, the countdown begins
for the designated soak time. Soak time hours can be set from 0 to 48. Soak time minutes can be set
from 0 to 45 in 15 minute increments.
•
Link State—Displays the status between signaling points at port and attached device. Allowed
values are UP or DOWN.
•
MTU (Maximum Transmission Unit)— Displays the largest acceptable packet size configured for
the port.
•
Speed—Displays the Ethernet port transmission speed.
•
Duplex—Displays the duplex mode setting for the port.
•
Flow Control—Displays the flow control mode negotiated with peer device.
•
Optics— Displays the Small form-factor pluggable (SFP) physical media type.
Step 4
Click
Apply.
Step 5
Reprovisioning an Ethernet port on the ML-Series card does not reset the ethernet statistics for that port.
The Ethernet Statistics must be refreshed. To do so, do the following:
a.
Click the
Performance
>
Ether Ports
>
Statistics
tabs.
b.
Click
Refresh.
Purpose
This task provisions the Ethernet ports of the ML-Series card to carry
traffic.
Tools/Equipment
None
Prerequisite Procedures
DLP-D60 Log into CTC, page 17-49
Required/As Needed
As needed
Onsite/Remote
Onsite
Security Level
Provisioning or higher
Summary of Contents for ONS 15454 SDH
