Cisco ONS 15454 SDH, Procedure Manual

Page: 440 / 860

17-26
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D32 Inspect the Shelf Installation and Connections
Step 3
Click the overhead circuit that you want to delete: local or express orderwire, user data channel,
IP-encapsulated tunnel, or DCC tunnel.
Step 4 Click Delete .
Step 5
In the confirmation dialog box, click Yes to continue.
Step 6 Return to your originating procedure (NTP).
DLP-D32 Inspect the Shelf Installation and Connections
Step 1 Check each wire and cable connection to make sure that all cables are locked securely. If a wire or cable
is loose, return to the appropriate procedure in
Chapter 1, “Install the Shelf and FMECs,” to correct it.
Step 2
To check that the front door is seated correctly, verify that it can be easily closed without disturbing fiber
or Ethernet patchcords.
Step 3
To check that the FMEC cover is seated correctly, verify that it can be easily closed without disturbing
cables.
Step 4
Return to your originating procedure (NTP).
DLP-D33 Measure Voltage
Step 1 Using a voltmeter, verify the office ground and power:
a.
Place the black lead (positive) on the frame ground on the bay. Hold it there while completing
Step
b.
b. Place the red lead (negative) on the fuse power points on the third-party power distribution panel to
verify that they read between –40.5 VDC and –57 VDC (power) and 0 (return ground).
Purpose Use this task to inspect the shelf installation and connections and verify that
everything is installed and connected properly.
Tools/Equipment None
Prerequisite Procedures Complete Table 1-2 on page 1-19 .
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
Purpose Use this task to measure the power to verify correct power and returns.
Tools/Equipment Voltmeter
Prerequisite Procedures Complete Table 1-2 on page 1-19 .
Required/As Needed Required
Onsite/Remote Onsite
Security Level None