Cisco ONS 15454 SDH, Procedure Manual

Page: 736 / 860

20-52
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D342 Change Line and Threshold Settings for the STM1E-12 Card
Table 20-23 describes the values on the Provisioning > Port tab for the STM1E-12 cards.
SF Ber Level Sets the signal fail bit error rate for
the configured VC12 or VC4 circuit.
•
1E-3
•
1E-4
•
1E-5
SD Ber Level Sets the signal degrade bit error rate
for the configured VC12 or VC4
circuit.
•
1E-5
• 1E-6
•
1E-7
• 1E-8
•
1E-9
Admin State
(Status) Sets the port service state unless
network conditions prevent the
change. For more information about
administrative states, refer to the
“Administrative and Service States”
appendix of the
Cisco ONS 15454 SDH Reference
Manual
.
• Unlocked—Puts the port in service. The
port service state changes to
Unlocked-enabled.
•
Unlocked,automaticInService—Puts the
port in automatic in-service. The port
service state changes to
Unlocked-disabled,automaticInService.
• Locked,disabled—Removes the port
from service and disables it. The port
service state changes to
Locked-enabled,disabled.
•
Locked,maintenance—Removes the port
from service for maintenance. The port
service state changes to
Locked-enabled,maintenance.
PJVC4Mon# Sets the VC4 that will be used for
pointer justification. If set to Off, no
VC4 is monitored. Only one VC4
can be monitored on each STM-N
port.
•
Off
• 1
AINS Soak Sets the automatic in-service soak
period.
•
Duration of valid input signal, in hh.mm
format, after which the card becomes
Unlocked-enabled automatically
•
0 to 48 hours, 15-minute increments
Table 20-22 Line Options for the STM1E-12 Card (continued)
Parameter Description Options
Table 20-23 Port Options for the STM1E-12 Card
Parameter Description Options
Port (Display only) Port number 1 to 12
Interface Interface type
•
STM1 (display only for Ports 1 through 8,
selectable for Ports 9 through 12)