Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 638 / 1218

12-4
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 12 Add and Remove Cards and Nodes
DLP-G318 Place OPT-BST and OPT-PRE Ports In Service
Step 7 Under Admin State, choose OOS,DSBLD or Locked,disabled (ETSI) for each port that does not have
an OOS-MA,DSBLD or Locked,disabled service state.
Step 8
Click Apply .
Step 9
In the confirmation dialog box, click Yes .
Step 10
Return to your originating procedure (NTP).
DLP-G318 Place OPT-BST and OPT-PRE Ports In Service
Step 1
On the shelf graphic in CTC, double-click the OPT-BST or OPT-PRE card with the ports that you want
to put in service.
Step 2 Click the Provisioning > Optical Line > Parameters tabs.
Step 3
Under Admin State, choose choose IS (ANSI) or Unlocked (ETSI) for Port 1 of the OPT-PRE or Ports
2 and 3 of the OPT-BST.
Step 4
Click Apply .
Step 5
In the confirmation dialog box, click Yes .
Step 6 Return to your originating procedure (NTP).
Purpose This task places OPT-BST and OPT-PRE card ports in service.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher