Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 400 / 1218

5-62
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G234 Change OTN Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
DLP-G234 Change OTN Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
Step 1
In node view, double-click the TXP_MR_2.5G or TXPP_MR_2.5G card where you want to change the
OTN settings.
Step 2
Click the Provisioning > OTN tabs, then choose one of the following subtabs: OTN Lines , G.709
Thresholds , FEC Thresholds , or Trail Trace Identifier .
Step 3 Modify any of the settings described in Tables 5-37 through 5-40 .
Note
You must modify Near End and Far End; 15 Min and 1 Day; and SM and PM independently. To
do so, choose the appropriate radio button and click
Refresh .
Table 5-37 describes the values on the Provisioning > OTN > OTN Lines tab.
Table 5-38 describes the values on the Provisioning > OTN > G.709 Thresholds tab.
Purpose This task changes the OTN settings for TXP_MR_2.5G and
TXPP_MR_2.5G transponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-37 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card OTN Line Settings
Parameter Description Options
Port # (Display only) Displays the port number. 2
G.709 OTN Sets the OTN lines according to
ITU-T G.709. • Enabled
•
Disabled
FEC Sets the OTN lines to FEC.
•
Enabled
• Disabled
SF BER Sets the signal fail bit error rate.
•
1E-5
SD BER Sets the signal degrade bit error rate.
•
1E-5
•
1E-6
•
1E-7
• 1E-8
•
1E-9