Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 389 / 1218

5-51
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G230 Change Line Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
Table 5-30 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card Line Settings
Parameter Description Options
Port # (Display only) Displays the port number.
•
1
• 2
•
3 (TXPP_MR_2.5G card only)
Port Name The user can assign a logical name for each of the
ports shown by filling in this field. User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the “DLP-G104 Assign a Name to a Port” task
on page 7-10 .
Admin State Sets the port service state unless network conditions
prevent the change. For more information about
administrative states, see
Appendix C, “DWDM
Administrative and Service States.”
•
IS (ANSI) or Unlocked (ETSI)
• IS,AINS (ANSI) or
Unlocked,automaticInService (ETSI)
•
OOS,DSBLD (ANSI) or Locked,disabled
(ETSI)
•
OOS,MT (ANSI) or Locked,maintenance
(ETSI)
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service states
appear in the format: Primary State-Primary State
Qualifier, Secondary State. For more information
about service states, see
Appendix C, “DWDM
Administrative and Service States.”
• IS-NR (ANSI) or Unlocked-enabled (ETSI)
•
OOS-AU,AINS (ANSI) or Unlocked-disabled,
automaticInService (ETSI)
•
OOS-MA,DSBLD (ANSI) or
Locked-enabled,disabled (ETSI)
•
OOS-MA,MT (ANSI) or
Locked-enabled,maintenance (ETSI)
ALS Mode Sets the ALS function mode. The DWDM
transmitter supports ALS according to ITU-T G.644
(06/99). ALS can be disabled or can be set for one of
three mode options.
•
Disable (default): ALS is off; the laser is not
automatically shut down when traffic outages
(LOS) occur.
•
Auto Restart: ALS is on; the laser automatically
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
• Manual Restart: ALS is on; the laser
automatically shuts down when traffic outages
(LOS) occur. However, the laser must be
manually restarted when conditions that caused
the outage are resolved.
•
Manual Restart for Test: Manually restarts the
laser for testing.
SF BER (OC-N and STM-N payloads only) Sets the signal
fail bit error rate.
•
1E-3
• 1E-4
•
1E-5