Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 571 / 1218

10-45
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
NTP-G88 Modify Users and Change Security
Step 6 In the BITS In section, you can change the following information:
Note The BITS Facilities section sets the parameters for your BITS1 and BITS2 timing references.
Many of these settings are determined by the timing source manufacturer. If equipment is timed
through BITS Out, you can set timing parameters to meet the requirements of the equipment.
•
BITS In State
•
Coding
• State
•
Framing
•
Sync Messaging
•
Admin SSM
Step 7
In the BITS In section, you can change the following information:
•
BITS Out State
• Coding
•
Framing
•
AIS Threshold
•
LBO
Step 8
Click Apply . Confirm that the changes appear.
Caution
Internal timing is Stratum 3 and is not intended for permanent use. All ONS 15454s should be timed to
a Stratum 2 or better primary reference source.
Step 9
Complete the “NTP-G103 Back Up the Database” procedure on page 13-2 .
Stop. You have completed this procedure.
NTP-G88 Modify Users and Change Security
Step 1
Complete the “DLP-G46 Log into CTC” task on page 2-25 . If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2 .
Purpose This procedure modifies user and security properties for the ONS 15454.
Tools/Equipment None
Prerequisite Procedures NTP-G23 Create Users and Assign Security, page 3-5
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser