Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 377 / 1218

5-39
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Step 4
Click Apply .
Step 5 Return to your originating procedure (NTP).
DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and
MXP_2.5G_10E Cards
Step 1 In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
line threshold settings.
Step 2
Click the Provisioning > Line Thresholds tabs.
Step 3
Modify any of the settings described in Table 5-18 .
ALS Mode Sets the ALS function mode. The DWDM
transmitter supports ALS according to ITU-T G.644
(06/99). ALS can be disabled or can be set for one of
three mode options. • Disable (default): ALS is off; the laser is not
automatically shut down when traffic outages
(LOS) occur.
•
Auto Restart: ALS is on; the laser automatically
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
• Manual Restart: ALS is on; the laser
automatically shuts down when traffic outages
(LOS) occur. However, the laser must be
manually restarted when conditions that caused
the outage are resolved.
•
Manual Restart for Test: Manually restarts the
laser for testing.
AINS Soak (OC-N and STM-N payloads only) Sets the
automatic in-service soak period.
•
Duration of valid input signal, in hh.mm format,
after which the card becomes in service (IS)
automatically
•
0 to 48 hours, 15-minute increments
Purpose This task changes the line threshold settings for MXP_2.5G_10G and
MXP_2.5G_10E muxponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-19 MXP_2.5G_10G and MXP_2.5G_10E Muxponder Card Trunk Settings (continued)
Parameter Description Options