11-3
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G199 Change the OSCM and OSC-CSM Optical Service Channel Settings
Table 11-1
OSCM and OSC-CSM Card OC-3 Settings
Parameter
Description
Options
Port #
Displays the port number.
Display only
Port Name
Provides the ability to assign the specified port
a name.
User-defined. Name can be up to 32 alphanumeric/special
characters. Blank by default.
See the
“DLP-G104 Assign a Name to a Port” task on
.
SF BER
Sets the signal fail bit error rate.
From the drop-down list, choose one of the following:
•
1E-3
•
1E-4
•
1E-5
SD BER
Sets the signal degrade bit error rate.
From the drop-down list, choose one of the following:
•
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
Provides
Synch
(Display only) If checked, the card is
provisioned as a network element (NE) timing
reference.
•
Checked
•
Unchecked
SynMsgIn
Enables synchronization status messages
(SSM) on the S1 byte, which allow the node to
choose the best timing source.
•
Checked
•
Unchecked
Send Do Not
Use
When checked, sends a Do Not Use for
Synchronization (DUS) message on the S1
byte.
•
Checked
•
Unchecked
PJSTSMon #
(Display only) Sets the STS that will be used
for pointer justification. If set to 0, no STS is
monitored. Only one STS can be monitored on
each OC-N port.
From the drop-down list, choose one of the following:
•
On
•
Off
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...
