Integrating Voice Mail with Cisco Unified SRST
How to Integrate Voice Mail with Cisco Unified SCCP and SIP SRST
239
Cisco Unified SCCP and SIP SRST System Administrator Guide
OL-13143-04
Step 4
forward-digits
{
num-digit
|
all
|
extra
}
Example:
Router(config-dial-peer)#
forward-digits all
(Optional for FXO or FXS) Specifies which digits to forward
for voice calls.
•
num-digit
: The number of digits to be forwarded. If the
number of digits is greater than the length of a destination
phone number, the length of the destination number is used.
Range is 0 to 32. Setting the value to 0 is equivalent to
entering the
no forward-digits
command.
•
all
: Forwards all digits. If
all
is entered, the full length of
the destination pattern is used.
•
extra
: If the length of the dialed digit string is greater than
the length of the dial-peer destination pattern, the extra
right-justified digits are forwarded. However, if the
dial-peer destination pattern is variable length and ends
with the character “T” (for example: T, 123T, 123...T),
extra digits are not forwarded.
Step 5
exit
Example:
Router(config-dial-peer)#
exit
(FXO or FXS and BRI or PRI) Exits dial-peer configuration
mode.
Table 1
Valid Entries for the String Argument in the destination-pattern command
Entry
Description
Digits 0 to 9
—
Letters A through D
—
Asterisk (*) and pound sign (#)
These appear on standard touch-tone dial pads.
Comma (,)
Inserts a pause between digits.
Period (.)
Matches any entered digit (this character is used as a wildcard).
Percent sign (%)
Indicates that the preceding digit occurred zero or more times; similar to the wildcard
usage.
Plus sign (+)
Indicates that the preceding digit occurred one or more times.
Note
The plus sign used as part of a digit string is different from the plus sign that
can be used in front of a digit string to indicate that the string is an E.164
standard number.
Circumflex (^)
Indicates a match to the beginning of the string.
Parentheses ( ( ) ), which indicate a pattern and are the same as the regular expression
rule.
Dollar sign ($)
Matches the null string at the end of the input string.
Backslash symbol (\)
Is followed by a single character and matches that character. Can be used with a single
character with no other significance (matching that character).
Question mark (?)
Indicates that the preceding digit occurred zero or one time.
Brackets ( [ ] )
Indicates a range. A range is a sequence of characters enclosed in the brackets; only
numeric characters from 0 to 9 are allowed in the range.
Command or Action
Purpose