Cisco Unified SCCP and SIP SRST Feature Overview
Where to Go Next
25
Cisco Unified SCCP and SIP SRST System Administrator Guide
OL-13143-04
Signal Support
Cisco Unified SRST supports FXS, FXO, T1, E1, and E1 R2 signals.
Language Support
See
Cisco Unified Communications Manager Express Cisco Unified CME Localization Matrix
.
Switch Support
Cisco SRST 3.2 and later versions support all PRI and BRI switches including the following:
•
basic-1tr6
•
basic-5ess
•
basic-dms100
•
basic-net3
•
basic-ni
•
basic-ntt NTT switch type for Japan
•
basic-ts013
•
primary-4ess Lucent 4ESS switch type for the United States
•
primary-5ess Lucent 5ESS switch type for the United States
•
primary-dms100 Northern Telecom DMS-100 switch type for the United States
•
primary-net5 NET5 switch type for the United Kingdom, Europe, Asia, and Australia
•
primary-ni National ISDN switch type for the United States
•
primary-ntt NTT switch type for Japan
•
primary-qsig QSIG switch type
•
primary-ts014 TS014 switch type for Australia (obsolete)
Where to Go Next
The next chapters of this book describe how to configure Cisco Unified SIP SRST. As shown in
Table 3
,
each chapter takes you through tasks in the order in which they need to be performed. The first task for
configuring Cisco Unified SRST is to ensure that the basic software and hardware in your system are
configured correctly for Cisco Unified SRST.
Table 3
Cisco Unified SRST Configuration Sequence
Task
Where Task Is Described
1.
Setting up a Cisco Unified SRST system
to communicate with your network
Setting Up the Network, page 63
2.
Configuring Version 4.1 features
Cisco Unified SIP SRST 4.1, page 75
3.
Setting up the basic Cisco Unified SRST
phone configuration using SCCP
Setting Up Cisco Unified IP Phones using SCCP,
page 85
