Cisco Unified SIP SRST 4.1
Where to Go Next
83
Cisco Unified SCCP and SIP SRST System Administrator Guide
OL-13143-04
DETAILED STEPS
Where to Go Next
The next step is configuring Cisco Unified IP phones using SCCP. For instructions, see the
“Setting Up
Cisco Unified IP Phones using SCCP” section on page 85
.
For additional information, see the
“Additional References” section on page 26
in the
“Cisco Unified
SCCP and SIP SRST Feature Overview”
chapter.
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure
terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
voice register global
Example:
Router(config)# voice register global
Enters voice register global configuration mode to set
global parameters for all supported SIP phones in a
Cisco Unified CME environment.
Step 4
system message
string
Example:
Router(config-register-global)# system message
fallback active
Defines a status message that displays on SIP phones
registered to Cisco Unified SRST.
•
string
: Up to 32 alphanumeric characters. Default is
“CM Fallback Service Operating.”
Step 5
end
Example:
Router(config-register-global)# end
Exits to privileged EXEC mode.
Step 6
show voice register global
Example:
Router# show voice register global
Displays all global configuration parameters associated
with SIP phones.