Setting Up Cisco Unified IP Phones using SCCP
How to Set Up Cisco Unified IP Phones
88
Cisco Unified SCCP and SIP SRST System Administrator Guide
OL-13143-04
Configuring Cisco Unified 8941 and 8945 SCCP IP Phones
To configure Cisco Unified 8941 and 8945 SCCP IP Phones in SRST mode, perform the following
commands:
Note
This section is required only in SRST version 8.6 and is not required for version 8.6 and higher.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ephone-type
phone-type
4.
device-id
number
5.
device-type
phone-type
6.
end
Step 5
limit-dn
phone-type
max-lines
Example:
Router(config-cm-fallback)# limit-dn 7945 2
(Optional) Limits the directory number lines on
Cisco IP phones during Cisco Unified CM fallback.
Note
You must configure this command during initial
Cisco Unified SRST router configuration, before
any phone actually registers with the
Cisco Unified SRST router. However, you can
modify the number of lines at a later time.
For a list of available phones, see
Cisco SRST
and SIP SRST Command Reference (All
Versions)
.
The setting for maximum lines is from 1 to 6. The default
number of maximum directory lines is set to 6. If there is
any active phone with the last line number greater than
this limit, warning information is displayed for phone
reset.
Step 6
exit
Example:
Router(config-cm-fallback)# exit
Exits call-manager-fallback configuration mode.
Command or Action
Purpose
