Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 281 / 318

4-25
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-3242 An {1} exists on the selected ports.
Therefore, you must create the {0}s one by one.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
WID-3243 The port you have chosen as an {0} endpoint already supports
an {1}. The port cannot support both DCCs. After the {0} is
created, verify that no EOC alarms are present and then delete
the {1} to complete the downgrade. The same port can not be used by multiple
DCCs.
EID-3244 An {0} exists on the selected ports.
Therefore, you must create the {1}s one by one.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
WID-3245 The port you have chosen as an {1} endpoint already supports
an {0}. The port cannot support both DCCs. After the {1} is
created, verify that no EOC alarms are present and then delete
the {0} to complete the upgrade. The port selected as a DCC endpoint
already supports another DCC. Refer to the
warning message text.
EID-3246 The wizard was not able to validate the data.
{0}
CTC encountered an error.
EID-3247 An ordering error occurred. The absolute value should be {0}. The absolute value entered was wrong.
EID-3248 The value for the parameter {0} is invalid. CTC changed the incorrect parameter.
EID-3249 The voltage increment value is invalid. Refer to the error message text.
EID-3250 The power monitor range is invalid. Refer to the error message text.
EID-3251 The requested action could not be completed.
{0}
CTC could not complete the specified
action.
EID-3252 No download has been initiated from this CTC session. Refer to the error message text.
EID-3253 The reboot operation failed. {0} Refer to the error message text.
EID-3254 An error occurred during validation. {0} The CTC was unable to validate the values
entered by the user, specified by {0}. This
error message is common to several
different provisioning tabs within the CTC.
EID-3255 You cannot change the timing configuration because a
Manual/Force operation is in effect. Refer to the error message text.
WID-3256 The timing reference(s) could not be assigned because one or
more of the timing reference(s):
- is already used and/or
- has been selected twice and/or
- is attempting to use the same slot twice.
Please verify the settings.
Refer to the warning message text.
EID-3257 Duplicate DCC numbers are not permitted. {0}. CTC detected more than one occurene of
the a DCC number. Remove one of them.
EID-3258 A software error occurred while attempting to download the
file.
Please try again later.
Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description