Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 269 / 318

4-13
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-2188 The nodes in this ring do not support alphanumeric IDs. Please
use a ring ID between {0} and {1}. The ring ID should not contain
alphanumeric characters, and must be in the
specified range.
EID-2189 The TL1 keyword "all" cannot be used as the ring name.
Please provide another name.
Refer to the error message text.
EID-2190 Adding this span will cause the ring to contain more nodes than
allowed. You have reached the maximum number of
nodes allowed.
EID-2191 The ring name must not be empty. You must supply a ring name.
EID-2192 A valid route cannot be found for the circuit creation request. CTC could not complete the circuit creation
request either beacuse there are no physical
links, or the bandwidth of the available
links are already reserved.
EID-2193 A valid route cannot be found for the circuit drop creation
request. Refer to the error message text.
EID-2194 A valid route cannot be found for the roll creation request. Refer to the error message text.
EID-2195 The circuit VLAN list cannot be mapped to one spanning tree.
You can view the VLAN/Spanning Tree table or reassign
VLANs.
Refer to the error message text.
EID-2196 CTC cannot be relaunched.
{0}
There is an error relaunching CTC.
EID-2197 A CORBA failure occurred. CTC cannot proceed. There was a CORBA failure, and the task
cannot proceed. Verify the Java version.
EID-2198 CTC is unable to switch to the {0} view. CTC is unable to switch to the specified
view.
EID-2199 Login failed on {0} {1} The login failed on the specified tasks.
EID-2200 CTC has detected a jar file deletion. The jar file was used to
manage one or more nodes. This CTC session will not be able
to manage those nodes and they will appear gray on the network
map. It is recommended that you exit this CTC session and start
a new one. Refer to the error message text.
EID-2202 An intra-node DRI circuit must have two sources. Intranode circuit must have two sources to
be a dual ring interconnect (DRI).
EID-2203 No member was selected. You must select a member.
EID-2204 The number of circuits must be a positive integer. The number of circuits cannot be zero or
negative.
EID-2205 The circuit type must be selected. You must select a circuit type.
EID-2206 The profile cannot be autoselected. Please select profile(s) to
store and try again. Refer to the error message text.
EID-2207 You cannot add this span. Either the ring name is too long (that
is, ring name length is greater than {0}) or the endpoints do not
support alphanumeric IDs. Reduce the length of the ring name, or
remove the alphanumberic characters from
the endpoints.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description