Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 272 / 318

4-16
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-3007 An error occurred while provisioning the {0}. There was a provisioning error for the
specified item.
EID-3008 This is not a valid card. You cannot perform DWDM automatic
node setup (ANS) from the card view.
Please navigate to the node view and try
again.
EID-3009 No {0} was selected. Select the specified item, for example,
VLAN, port, slot, etc.
EID-3010 A bidirectional optical link could not be created. Refer to the error message text.
EID-3016 The subnet address is invalid. Refer to the error message text.
EID-3017 The subnet address already exists. Refer to the error message text.
EID-3019 The internal subnet address is incomplete. Enter the complete internal subnet address.
EID-3020 The subnet address cannot be the same for both TSC cards.
The requested action is not allowed.
A node’s internal subnet must be different
from one another as each TSC is on separate
ethernet buses, isolated by broadcast
domains.
EID-3021 An error occurred while retrieving the diagnostics:
{0}
Refer to the error message text.
EID-3022 The requested action is not allowed. The requested action is not allowed.
EID-3023 The low order cross-connect mode could not be retrieved. Refer to the error message text.
EID-3024 The {0} cross-connect mode could not be switched.
Please verify that the type and/or number of circuits
provisioned does not exceed the criterion for switching modes.
CTC cannot switch the cross-connect mode
for the specified item, as the type or the
number of circuits does not match with the
criterion for switching modes.
EID-3025 An error occurred while retrieving thresholds. There was an error retrieving the thresholds.
EID-3026 The send DoNotUse attribute cannot be modified. You cannot modify the Send DoNotUse
field.
EID-3027 The SyncMsg attribute cannot be modified. You cannot modify the SyncMsg field.
EID-3028 The port type cannot be changed. You cannot change the port type.
EID-3029 Unable to switch to the byte because an overhead change is
present on this byte of the port. Refer to the error message text.
EID-3031 An error occurred while hard-resetting the card. There was an error while resetting card
hardware.
EID-3032 An error occurred while resetting the card. There was an error while resetting the card.
EID-3033 The lamp test is not supported on this shelf. Refer to the error message text.
EID-3035 The cross-connect diagnostics cannot be performed Refer to the error message text.
EID-3036 The cross-connect diagnostics test is not supported on this
shelf. The cross-connect diagnostics test is not
supported on this shelf.
EID-3039 An error occurred while changing the card type. There was an error while changing the card.
EID-3040 The card type is invalid. The selected card type is invalid.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description