Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 301 / 318

4-45
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-6144 The port provisioning cannot be changed when the port media
is Undefined. If the port is not preprovisioned with the
type of media that is going to be inserted,
you cannot access any of the existing values
for the port.
WID-6145 OSPF on LAN should only be enabled when the LAN routers
run OSPF. Otherwise, the node will not be reachable from
outside its subnet.
RIP implementation only advertise routes in one direction to
connected routers. It does not learn or distribute routes
advertised by other routers.
Also note that enabling OSPF on the LAN will temporarily
cause the current list of static routes to stop being advertised to
remote nodes and only be used locally.
Refer to the warning message text.
WID-6146 Deleting the protection group while in a switched state might
cause a loss of traffic. It is recommended that you verify switch
states before proceeding. Refer to the warning message text.
EID-6147 The protection switch could not be performed. A protection switch cannot be performed
during protection operations like manual
switch, lockout, and so on.
EID-6148 A server trail is present. Refer to the warning message text.
EID-6149 The LAPD MTU size must be greater than or equal to the {0}
LSP buffer size {1}. Alternatively, you can decrease the {0}
LSP buffer size to {2}. Refer to the error message text.
EID-6150 The value is out of range. Enter a value that is within the range.
EID-6151 The minimum span loss must be less than the maximum span
loss. Refer to the error message text.
EID-6152 The "Use NTP/SNTP Server" field is checked. Enter the
NTP/SNTP server IP address or server name. Enter the NTP/SNTP server name. To leave
this field empty, uncheck the “Use
NTP/SNTP Server" and proceed.
EID-6153 The maximum frame size is invalid. Refer to the error message text.
EID-6154 To combine unidirectional two-port provisioning and
autonegotiation on the same port, autonegotiation must be set
first. Refer to the error message text.
EID-6155 Transponder mode cannot be provisioned with circuits on the
card. Refer to the error message text.
EID-6156 The transponder configuration is invalid. The transponder is not configured properly.
EID-6157 The watermark values are either out of range or inconsistent. Enter valid watermark values.
EID-6179 The 1+1 protection group is not optimized. Refer to the error message text.
EID-6196 The equipment has failed or is missing. Operation is requested on a failed or
missing equipment.
EID-6197 Attributes cannot be changed when the port administrative state
is {0}. You cannot change the attributes when the
port is in the specified administrative state.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description