Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 289 / 318

4-33
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-4010 The operation was terminated because:
{0}
Refer to the error message text.
EID-4011 An error occurred during provisioning:
{0}
Refer to the error message text.
EID-5000 A valid route cannot be found for the tunnel change request. Refer to the error message text.
EID-5001 The tunnel could not be changed. Refer to the error message text.
EID-5002 The tunnel could not be restored and must be recreated
manually. Refer to the error message text.
EID-5003 The circuit roll failed.
{0}
Refer to the error message text.
EID-5004 There is already one four-fiber {0} provisioned on the set of
nodes involved in {1}. The maximum number of four-fiber {0}
rings has been reached for that node. There is already one 4-fiber MS-SPRing
provisioned on the set of nodes involved in
the ring. The maximum number of 4-fiber
MS-SPRing rings has been reached for that
node.
WID-5005 A non-zero hold-off time can violate switching time standards,
and should only be used for a circuit with multiple path
selectors. Refer to the warning message text.
WID-5006 Warning: A different secondary {0} node should only be used
for DRI or open-ended path protected circuits. You should use different secondary end
point only for DRI or open-ended path
protected circuits.
WID-5007 If you change the scope of this view, the contents of this profile
editor will be lost. Refer to the warning message text.
WID-5008 Please ensure that all the protection groups are in proper states
after the cancellation. Refer to the warning message text.
WID-5009 The circuit {0} is not upgradable.
No {1} capable {2}s are available at the node {3}.
No VT-capable STSs are available at the
node.
EID-5010 The domain name already exists. Refer to the error message text.
EID-5011 The domain name cannot exceed {0} characters. You may have reached the maximum
number of charcters.
WID-5012 The software load on {0} does not support the addition of a
node to a 1+1 protection group. Refer to the warning message text.
EID-5013 {0} does not support the bridge and roll feature. Please select a
different port. The specified port does not support Bridge
and Roll.
EID-5014 An automatic network layout is already in progress.
Please wait for it to complete before running it again.
You must for the automatic network layout
to complete before running it again.
WID-5015 {0} cannot be applied to {1}. You cannot apply the admin state operation,
specified by {0}, to port count, specified by
{1}.
EID-5016 An error occurred while attempting to provision the {0}.
{1}
CTC encountered an error while
provisioning the card.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description