Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 282 / 318

4-26
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-3259 An error occurred while creating the FC-MR threshold. You must create a Fibre Channel Multirate
(FC_MR) card threshold.
EID-3260 An error occurred while provisioning the internal subnet:
{0}
The specified internal subnet could not be
provisoned.
EID-3261 The port rate provisioning cannot be changed while circuits
exist on this port. Refer to the error message text.
EID-3262 The port provisioning cannot be changed when the port status
is {0}. You must provision the ports only when the
port is Out of Service.
WID-3263 You are using Java version {0}. CTC should run with Java
version {1}. It can be obtained from the installation CD or
http://java.sun.com/j2se/ CTC is being launched with the wrong
version of the JRE {0}. This version of CTC
requires a particular version of the JRE {1}.
The CTC and browser must be closed and
restarted to allow the correct Java version to
be loaded.
EID-3265 An error occurred while modifying the protection group. The protection group could not be modified.
EID-3266 Conditions could not be retrieved from the shelf or card view. Refer to the error message text.
WID-3267 The XTC protection group cannot be modified. Refer to the warning message text.
WID-3268 The filter entry is invalid. {0} The specified entry is invalid.
WID-3269 The {0} operation was successfully initiated for {1} but its
completion status could not be obtained from the node. When
the node is accessible, check its software version to verify if the
{0} succeeded. Refer to the error message text.
WID-3270 The file {0} does not exist. The specified file does not exist.
WID-3271 The value entered must be greater than {0}. The value entered must be greater than the
specified value.
WID-3272 An entry is required. An entry is required to complete this task.
WID-3273 {0} already exists in the list. The specified item already exists in the list.
WID-3274 A software upgrade is in progress.
Network configuration changes that result in a node reboot
cannot take place during a software upgrade.
Please try again after the software upgrade is done.
Refer to the warning message text.
WID-3275 Ensure that the remote interface ID and the local interface ID
on the two sides match.
(The local interface ID on this node should equal the remote
interface ID on the neighbor node and vice-versa).
Refer to the warning message text.
WID-3276 Both {0} and {1} exist on the same selected port.
{2}
The specified port has both MS-DCC and
RS-DCC.
WID-3277 The description cannot exceed {0} characters. Your input will
be truncated. The input exceeds the character limit. The
value will be truncated to the maximum
chacter limit.
WID-3279 This card has been deleted. CTC will return to the shelf view. CTC returns to node view.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description