Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 277 / 318

4-21
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-3132 An error occurred while setting the OSPF area range: {0}, {1},
false. CTC encountered an error while setting the
area range for the specified values.
EID-3133 The maximum number of OSPF area ranges has been exceeded. OSPF area ranges exceeded the maximum
number.
EID-3134 The area ID is invalid. Use the DCC OSPF area ID, LAN port
area ID, or 0.0.0.0. Refer to the error message text.
EID-3135 The mask is invalid. Refer to the error message text.
EID-3136 The range address is invalid. The range address is invalid. Try again.
EID-3137 Your request has been denied because the timing source
information was updated while your changes were still
pending. Please retry. Refer to the error message text.
EID-3138 The clock source for switching is invalid. You have selected an invalid clock source.
Choose another clock.
EID-3139 A switch cannot be made to a reference of inferior quality. Refer to the error message text.
EID-3140 A higher priority switch is already active. You cannot switch the timing source
manually when a higher priority switch is
already active.
EID-3141 An attempt was made to access a bad reference. Refer to the error message text.
EID-3142 No switch is active. None of the switches are active.
EID-3143 An error occurred while creating the static route entry. CTC encountered an error while a creating
static route entry.
EID-3144 The maximum number of static routes has been exceeded. The number of static routes has exceeded its
limit.
EID-3145 The RIP metric must be between 1 and 15. The Routing Information Protocol (RIP)
metric should be in the range of 1 to 15.
EID-3146 The RIP metric is invalid. Refer to the error message text.
EID-3147 An error occurred while creating the summary address. There was an error while creating the
summary address.
EID-3148 No Layer 2 domain has been provisioned. You must provision any one of the Layer 2
domain.
EID-3149 The MAC addresses could not be retrieved. Refer to the error message text.
EID-3150 The target file {0} is not a normal file. The specified target file is not a normal file.
EID-3151 The target file {0} is not writable. The target file is not writeable. Specify
another file.
EID-3152 An error occurred while creating the protection group. CTC encountered an error creating
Protection Group.
EID-3153 The card cannot be deleted because it is in use. Refer to the error message text.
EID-3154 An error occurred while provisioning the card:
CTC cannot {0} the card.
CTC cannot perform the task on the card.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description