Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 260 / 318

4-4
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-2004 No Cisco IOS slot was selected. You did not select a Cisco IOS slot.
EID-2005 CTC cannot find the online help files for {0}.
The files might have been moved, deleted, or not installed.
To install online help, run the setup program on the software or
documentation CDs.
CTC cannot find the online help files for the
specified window. The files might have
been moved, deleted, or not installed. To
install online help, run the setup program on
the software CD.
EID-2006 An error occurred while editing the circuit(s).
{0}
{1}.
An error occurred when CTC tried to open
the circuit for editing.
EID-2007 The preferences could not be saved. CTC cannot save the preferences.
EID-2008 The circuit preferences could not be saved:
{0}
CTC cannot find the file needed to save the
circuit preferences.
EID-2009 CTC was unable to download the package:
{0}
Refer to the error message text.
EID-2010 An error occurred while deleting the destination. CTC could not delete the destination.
EID-2011 The circuit could not be destroyed. CTC could not destroy the circuit.
EID-2012 The reverse circuit could not be destroyed. CTC could not reverse the circuit destroy.
EID-2013 The circuit creation failed.
The circuit creation cannot proceed due to changes in the
network which affected the circuit(s) being created.
The dialog box will close. Please try again.
Refer to the error message text.
EID-2014 No circuit(s) were selected.
{0}
You must select a circuit to complete this
function.
EID-2015 The circuit {0} cannot be deleted because it has one or more
rolls. You must delete the rolls in the circuit
before deleting the circuit itself.
EID-2016 The circuit deletion failed. CTC could not delete the tunnel as there are
circuits that use the tunnel.
EID-2017 An error occurred while mapping the circuit.
{0}
There was an error mapping the circuit.
EID-2018 The circuit roll failed.
The circuit must be in the DISCOVERED state in order to
perform a roll.
There was a failure in circuit roll. Change
the circuit state to DISCOVERED and
proceed.
EID-2019 The circuit roll failed.
Bridge and roll is not supported on DWDM circuits.
Refer to the error message text.
EID-2020 The circuit roll failed.
The two circuits must have the same direction.
Refer to the error message text.
EID-2021 The circuit roll failed.
The two circuits must have the same size.
Refer to the error message text.
EID-2022 The circuit roll failed.
A maximum of two circuits can be selected for a bridge and roll
operation.
Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description