Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 284 / 318

4-28
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-3303 The DCC area ID and {0} conflict.
{1}
DCC Area ID and ring type, specified by
{0}, conflict each other due to the details
specified by {1}.
EID-3304 The DCC number is out of range. Enter a DCC number that is within the
range.
EID-3305 OSPF cannot be active on the LAN interface when the
backbone area is set on a DCC interface. You cannot have the default OSPF area on a
DCC while OSPF is enabled on the LAN.
EID-3306 Ethernet circuits must be bidirectional. Refer to the error message text.
EID-3307 An error occurred while creating a connection object at {0}. CTC encountered an error at the specified
connection while creating the connection.
EID-3308 DWDM links can be used only for optical channel circuits. Refer to the error message text.
EID-3309 The link was excluded because it was in the wrong direction. The optical channel (circuit) does not allow
the specified link to be included because it
is in the wrong optical direction.
EID-3310 The DWDM link does not have wavelengths available. Refer to the error message text.
EID-3311 The laser is already on. Refer to the error message text.
EID-3312 The power setpoint cannot be changed.
{0} {1}
CTC cannot change change the power
setpoint. The new setpoint would either
make the thresholds inconsistent or set the
fail threshold outside the range.
EID-3313 The offset cannot be modified because the service state of the
port is IS. Refer to the error message text.
EID-3314 The requested action is not allowed.
The state value is invalid.
Refer to the error message text.
EID-3315 This operation cannot be performed. CTC is unable to perform operation.
EID-3316 The node side is invalid. This task was applied to the wrong node
side.
EID-3317 The ring name is too long. Reduce the number of charcters in the
name.
EID-3318 The ring name is invalid. The name you entered is illegal.
EID-3319 The wrong line was selected. Select another line.
EID-3320 The optical link could not be deleted. CTC cannot delete the optical link.
EID-3321 This feature is unsupported by this version of software. Refer to the error message text.
EID-3322 The equipment is not plugged in. Plug in the equipment and proceed.
EID-3323 The APC system is busy. Automatic power control (APC) system is
busy.
EID-3324 There is no path to regulate. There is no circuit path to regulate.
EID-3325 The requested action is not allowed. Generic DWDM provisioning failure
message.
EID-3326 The input was invalid. The input value is incorrect.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description