Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 267 / 318

4-11
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
WID-2156 The manual roll mode is recommended for dual rolls.
For auto dual rolls, please verify that roll to facilities are in
service and error-free.
Refer to the warning message text.
WID-2157 The roll(s) cannot be completed.
{0}
CTC could not complete the roll because
the roll is destroyed, in an incomplete state,
in a TL1_roll state, is cancelled, or is not
ready to complete.
EID-2158 The roll mode is invalid.
{0}
There are two roll modes: auto and manual.
For a one-way circuit source roll, the roll
mode must be auto and for a one-way circuit
destination roll, the roll mode must be
manual.
EID-2159 The roll is not ready for completion.
{0}
The roll is not ready for completion.
EID-2160 The roll is not connected.
{0}
Refer to error messge text.
EID-2161 The sibling roll is not complete.
{0}
One of the rolls is not completed for the
dual roll. If it is auto roll, it will be
completed when a valid signal is detected.
If it is a manual roll, you must complete the
roll from CTC if Bridge and Roll is
operated from CTC, or from TL1 if Bridge
and Roll is operated from TL1.
EID-2162 An error occurred during roll acknowledgement.
{0}
Refer to the error message text.
EID-2163 The roll cannot be canceled.
{0}
CTC cannot cancel the roll.
EID-2164 An error occurred during the roll.
{0}
CTC encountered a roll error.
WID-2165 The MAC address of the node {0} has been changed. All
circuits originating from or dropping at this node will need to
be repaired. Repair the circuits that originate from or
drop at the specified node, with the new
MAC address.
WID-2166 The node cannot be inserted into the domain because it is not
initialized. Initialize the node and proceed.
WID-2167 You have insufficient security privileges to perform this action. You do not have the previlege to perform
this action.
WID-2168 The following warnings surfaced while loading {0}.
{1}
CTC encountered warnings while loading
the alarm profile import file.
WID-2169 One or more of the profiles selected do not exist on one or more
of the nodes selected. The profile selected does not exist on the
node. Select another profile.
WID-2170 The profile list on node {0} is full. Please delete one or more
profiles if you wish to add the profile.
{1}
The number of profile that can exist on a
node has reached the limit. To add a profile,
delete any of the existing profiles.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description