Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 263 / 318

4-7
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-2065 The profile cannot be imported.
The profile "{0}" exists in the editor and the maximum number
of copies (ten) exists in the editor.
The import will be aborted. The profile has already been loaded
eleven times.
Cannot import the profile because the
profile has reached the maximum number of
copies in the editor.
EID-2066 The profile could not be stored.
An error occurred while writing to {0}.
CTC encountered an error while trying to
store the profile.
EID-2067 An error occurred while writing to the file.
{0}
CTC encountered an error while writing the
specified file.
EID-2068 The alarm profile could not be loaded from the node. CTC encountered an error trying to load the
alarm profile from the node.
EID-2069 The file could not be found or an I/O exception occurred.
{0}
Either the specified file was not found, or
there was an input/output exception.
EID-2070 The profile could not be deleted.
{0}
There was a failure in deleting the specified
profile.
EID-2071 Only one column may be highlighted. You cannot select more than one column
during clone action.
EID-2072 Only one profile may be highlighted. You cannot select more than one profile.
EID-2073 This column is permanent and cannot be removed. You cannot delete a permanent column.
EID-2074 Select one or more profiles. You have not selected any profile or
column. Reset operation is done by
right-clicking the selected column.
EID-2075 This column is permanent and cannot be reset. A permanent column is non resettable.
EID-2077 This column is permanent and cannot be renamed. You cannot rename a permanent column.
EID-2078 At least two columns must be highlighted. You connot compare two profiles unless
you select two columns.
EID-2079 The alarm types cannot be loaded into table.
There are no reachable nodes from which the list of alarm types
can be loaded.
Please wait until such a node is reachable and try again.
Refer to the error message text.
EID-2080 The node {0} has no profiles. The specified node does not have any
profiles.
EID-2081 An error occurred while removing profile {0} from the node
{1}. There was an error while removing the
specified profile from the specified node.
EID-2082 The profile {0} does not exist on the node {1}. CTC cannot find the specified profile from
the specified node.
EID-2083 An error occurred while adding profile {0} to the node {1}. There was an error adding the specified
profile to the specified node.
EID-2085 The profile selection is invalid.
No profiles were selected.
You tried to select an invalid profile. Select
another profile.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description