doseBadge⁵ noise dosimeter - instrument handbook
17
The doseBadge5 has no controls, cables or displays so the wearer cannot tamper with the
scheduled measurements. The timers can be also enabled on specific days of the week (to
exclude weekends for example).
Up to three time periods can be programmed allowing for breaks to be automatically
excluded (where standards require this).
If scheduled measurements are enabled, they will only be active when your doseBadge
is removed from a powered dock. This allows timers to be enabled and used only when
instruments are needed.
See page 45 for details of configuring the scheduled timers.
7.2
Configuring through NoiseTools
The NoiseTools software allows all of the configuration options on your doseBadge to be
adjusted.
Settings can be transferred between instruments and doseBadge5 units can be allocated to
a person, project and place before measurements are made. This information is downloaded
with the measurement data once the measurement is complete.
7.2.1
New Instrument Wizard
When a doseBadge5 is connected to an installation of NoiseTools that has not seen the
badge before, the New Instrument Wizard will run.
The wizard allows for the quick setup of new instruments and allows a pre-set integrator
configuration to be loaded into the instruments. The name of the instrument can also be
changed.
