OPERATION
3-2
Cine-IPM 2K User’s Manual
020-100164-01 Rev. 1 (01/08)
Communications
(FRONT)
Connect all external communication links here, such as a wired keypad, Ethernet,
and/or a serial link from your PC or another
Cine-IPM 2K
. See
Section 2
for details
of connection and setup of all communications.
RS232:
Connect an RS232-compatible PC or other controller for typical serial
communication to and from the
Cine-IPM 2K
. These in-out ports also provide
loop-through connection to additional
Cine-IPM 2Ks
, creating a serial
network, and are used for downloading new software to the
Cine-IPM 2K.
RS422:
Connect an RS422-compatible controller for unusually long-distance
serial communication.
GPIO:
Connect the desired GPIO-compatible device here for integration of the
Cine-IPM 2K
with an established control system. Devices connected via GPIO
can operate in tandem with
Cine-IPM 2K
, or vice versa and is often used for
automation of regularly scheduled events.
REMOTE KEYPAD:
Connect the wired (tethered) remote keypad if you want to
use a keypad for controlling a
Cine-IPM 2K,
such as one that is recessed and
hidden inside the
CP2000
pedestal. In such cases, the cable is typically routed
out the front toe of the pedestal.
ETHERNET:
Connect to an Ethernet network with other equipment such as
controllers and additional projectors.
Standard and Optional Inputs
Connect all desired non-cinema input sources here. See
Section 2
for more
information about connecting sources, and refer to
Section 6
for specifications.
Status Display
Full status and error messages appear in this window.
IR Sensor
The IR sensor detects commands from the
Cine-IPM 2K
IR remote keypad. Turn this
response on or off in the
Communications
menu.
Main Power Switch
When switched to
On
, the
Cine-IPM 2K
is ready for power-up and the
Status Display
window is functional—it shows “Power Off” until you press
on the keypad.
When switched to
Off
, the
Cine-IPM 2K
is disconnected from AC (similar to
unplugging the unit) and cannot be detected by the TPC.
AC Connector and Line Cord
Use the
Cine-IPM 2K
line cord for any installation. Plug into an appropriate wall
outlet or use the convenience outlet in the
CP2000
pedestal. The
Cine-IPM 2K
is
rated for 100-240 VAC—see
Section 6, Specifications
for more information.
Outputs and Communications to CP2000
(REAR)
All links to the
CP2000
and/or other display device are routed from the rear of the
Cine-IPM 2K.
DVI #1 and DVI #2:
The
Cine-IPM 2K
sends output through identical DVI ports
located on its rear panel—connect DVI-1 or both of these outputs to the
CP2000
and/or other display device (two DVI cables provided). See
2.3,
Connecting DVI Outputs
for details.
Summary of Contents for CineIPM-2K
