Christie CineIPM-2K, User Manual

Page: 24 / 122

INSTALLATION AND SETUP
2-18 Cine-IPM 2K User’s Manual
020-100164-01 Rev. 1 (01/08)
CHANGING THE PORT#:
On some Ethernet networks, firewall restrictions may
require that the port number of the Cine-IPM 2K be changed from its default of 3002.
If so, enter a new port number in the Ethernet Settings menu or include the new port#
in an XIP serial command sent to the Cine-IPM 2K . NOTE: It is recommended you
do not use port numbers below 1000 as they are typically reserved by common TCP
applications.
SUBNET MASK AND DEFAULT GATEWAY:
The Subnet Mask and Default Gateway are
automatically assigned when DHCP is enabled. If a static IP address is used, assign it
first since the subnet mask is estimated after it is entered. The Default Gateway
allows you to specify the address of a local router, which enables the transmission of
data between separate IP networks.
NETWORK NAME:
Set the name for the projector, as it should appear on the local
network. The control is most useful when DHCP is enabled, since the IP address may
change from one session to another.
ArtNet INTERFACE SETTINGS:
Refer to 3.6, Adjusting System Parameters and
Advanced Co ntrols for additional information about ArtNet settings.
By default, communications originating from one type of serial controller—RS232
vs. RS422 vs. Ethernet—stay on the corresponding network path. This separation is
indicated by a “Separate” setting for “Network Routing” in the
Communications
menu. If you are using an RS422 controller, for example, the device communicates
only with the Cine-IPM 2K to which it is connected unless you change this setting to
either “RS232 and RS422 Joined” or “All Joined”(Figure 2.25).
Figure 2.25. Keeping Communications Separate (default)
To relay all messages to all ports—RS232,
RS422, and Ethernet—set the “Network
Routing” option in the
Communications menu
for each projector to “All Joined”. This
configuration is useful if you are using a non-
RS232 controller with the RS232 linking
available between these
Cine-IPM 2Ks . For example, you may want to use both an
RS422-compatible controller and an Ethernet-connected PC for working with a
network of
Cine-IPM 2Ks linked via their RS232 in/out ports (Figure 2.26).
Communicating to
X
Certain Ports
Communicating to
X
All Ports Separate
RS232 and RS422 Joined
Ethernet Joined
All Joined
RS232 and
1.
2.
3.
4.