Christie CineIPM-2K, User Manual

Page: 21 / 122

INSTALLATION AND SETUP
Cine-IPM 2K User’s Manual 2-15
020-100164-01 Rev. 1 (01/08)
Cine-IPM 2K input (#1-6) for a specific display button. You can then
source-switch at any time by selecting this button on the TPC Main menu.
NOTE:
Using the TPC to select a specific Cine-IPM 2K input 1-6 requires
the
DVI-1
link. If
DVI-2
, you must use the keypad.
•
Define
DATA FORMAT
: 8-bit output requires “Unpacked 8-bit” data format. If
Input is set to
DVI-TWIN
(10-bit output), data format must be “Packed 10-
bit”. NOTE: “Packed 12-bit” is currently not supported.
•
Define
SOURCE
: Select the output resolution currently set in the Cine-IPM
2K— by default, this is 2048 x 1080 but other choices are available in the
Geometry and Color menu.
Figure 2.20. Configuring the TPC for Cine-IPM 2K Sources
(EXAMPLE)
•
Define
SCREEN
: Set to “2048 x 1080 No Crop” to use the full display area of
the projector. To use a smaller area, select one of the other screen options.
•
Set
GAMMA
to 2.6.
•
Set
COLOR SPACE
to Unity RGB.
•
Clear the
CINEMA
checkbox. To achieve maximum throughput, non-cinema
processing is recommended for all Cine-IPM 2K sources. In rare cases with
low resolution sources having limited bandwidth, you may find that the
cinema path can be used without cropping.
5. Choose a desired key name and icon for the display button appearing on the TPC
Main menu.
6. Settings are saved when you leave the Custom menu (they are also saved 5
minutes after opening the menu).
The TPC Main menu should now include a button for your newly-defined Cine-IPM
2K source. Repeat for remaining Cine-IPM 2K sources.
You may wish to link two or more Cine-IPM 2Ks together so that commands to and
from a controller are relayed from one projector to another (each one having its own
Cine-IPM 2K ). Choose a hardware configuration that best suits your desired
communication method.
2.6 Linking Multiple
Cine-IPM 2Ks