Christie CineIPM-2K, User Manual

Page: 11 / 122

INSTALLATION AND SETUP
Cine-IPM 2K User’s Manual 2-5
020-100164-01 Rev. 1 (01/08)
Select a Source
Using the remote keypad, press
Input 1
,
Input 2
,
Input 3
,
Input 4
,
Input 5
or
Input 6
to select the
corresponding source connected in Step 3. The image from this source will be
projected as a 2048 x 1080 display (default).
If desired, an installer, administrator or advanced user can configure the TPC for
Cine-IPM 2K source switching—see 2.5, Setting Up the TPC for Source Selection .
Press
Auto
Setup
and/or
Menu to refine other display parameters for this source as desired, or
to change to 10-bit output and/or a different resolution. See also 3.4, Using Inputs
and Channels.
Close/Lock Pedestal Doors
With the Cine-IPM 2K fully installed, you should need no further access to the
interior of the pedestal. In a recessed installation where the Cine-IPM 2K is
inaccessible, make sure to leave the Cine-IPM 2K main switch permanently set to
“on”.
Sources connect to the front panel of the Cine-IPM 2K. See Figure 2.7. To add a
source when the Cine-IPM 2K is recessed and secured within the CP2000 , a qualified
service technician must unlock and open the pedestal for access.
Input Panel
The upper right corner (
INPUT 1
) typically accepts an RGB signal from an external
analog RGB source, or it can also be used for YPbPr signals. Adjacent to these
BNCs, the DVI-I connector (
INPUT 2
) accepts digital or analog display signals from a
computer. Connect analog composite video at
INPUT 3
or S-video at
INPUT 4
from
devices such as VCRs, laser disk players or DVD players.
USING THE OPTIONAL SLOTS:
There are also several optional interfaces available for
connecting additional sources. These interfaces slide into the option slots #1 (
INPUT
5
) or #2 (
INPUT 6
)
,
and may be removed or installed while the Cine-IPM 2K is
powered up, if desired. Insert carefully along installation guides, making sure not to
touch the main board installed near the roof of the open slot.
Figure 2.7. Cine-IPM 2K Input Panel
NOTES: 1)
See Section 6, Specifications for details regarding compatible inputs.
2)
For all connections, use high quality shielded cables only.
STEP 9
X
STEP 10
X
2.2 Connecting
Sources