Chevrolet 1977 Monte Carlo, Repair Manual

Page: 173 / 428

AUTOMATIC TRANSMISSION (200) 7A1-5
GOVERNOR
COVER
607C2
Figure 7A1-24 Removing Governor Cover
Figure 7A1-25 Removing Intermediate Servo Retaining Ring
Figure 7A1-24A Removing Lead Wire
Figure 7A 1-26 Removing Intermediate Servo
e. A pply 12 N -m (100 lb. in.) o f torque to hex nut on
side o f gage. Slide dial indicator over pin J-25014-1. (Figure
7A 1-28). Read dial indicator and see chart below for proper
size.
NOTICE:
D ial indicator travel is reversed, m aking the
indicator readings backwards. On an indicator that
ranges from 0-100, a .5m m (.020") travel will read 2m m
(.080"), a 1.5mm (.060") travel will read 1mm (.040").
The identification ring is located on the band end o f the
pin.
Figure 7A1-24B Removing Electrical Connector
NOTICE:
If band selection pin does not register
between the high and low limits, look for possible
problem with the interm ediate band, direct clutch or
case.
f. R em ove tools J-25014-2 and J-25014-1.
11. Inspect the 3rd accum ulator check valve for the
follow ing conditions: m issing check ball, check ball binding
or stuck in tube, oil feed slot in tube m issing or restricted,
im properly assembled, loose fitting or not fully seated in
case and damaged or missing. (Figure 29A ).
If the 3rd accum ulator check valve assembly requires
replacement, perform the following:
ELEC T R IC A L!
CONNECTOR
INTERMEDIATE SERVO
J —28653
INTERMEDIATE SERVO
C O V E R S —
907A3
R E T A I N I N G
RING