Canon XF705, Instruction Manual

Page: 90 / 231

S etting the Time Code
90
About the time code di s play
An icon may appear next to the time code depending on the operation. Refer to the following table.
NOTES NOTES
• The frames value of the time code runs from 0 to 23 (frame rate set to 23.98P), from 0 to 24 (frame rate set to
25.00P, 50.00P or 50.00i), or from 0 to 29 (all other frame rates).
• However, if
>
[
B
"
System Setup]
>
[SDI/HDMI Scan Mode] is set to [PsF (Forced 1080i)], even
when the frame rate is set to 23.98P, the frames value of the time code output from the SDI terminal and HDMI
OUT terminal will be converted so it runs from 0 to 29.
• When slow motion recording is activated, you cannot select the [Free Run] running mode. Conversely, when
pre-recording is activated, [Free Run] is set automatically and cannot be changed.
• When slow motion recording is activated, the time code signal will not be output from the SDI terminal, HDMI
OUT terminal or TIME CODE terminal.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• When you are using the [Free Run] running mode, the time code will continue running as long as the built-in
backup battery has some charge left, even if you disconnect all other power sources.
• If you set an assignable button to [Time Code] (
A
117), you can press the button to open the
[
B
#
System Setup] menu page.
Icon De s cription
R The time code mode i s s et to [Regen.].
P The time code mode i s s et to [Pre s et] and the running mode i s s et to [Rec Run].
F The time code mode i s s et to [Pre s et] and the running mode i s s et to [Free Run].
E Time code s ignal i s coming from an external s ource.
H Time code di s play i s on hold.
No icon Time code during clip playback.