Canon XF705, Instruction Manual

Page: 38 / 231

Remote Operation of the Camcorder
38
Remote Operation of the Camcorder
The camcorder can be operated remotely in a number of different ways with varying degrees of control. First, you
can use the supplied wireless controller as described below. You can also connect an optional RC-V100 Remote
Controller for maximum control of your recordings at a professional level.
Finally, you can connect a network device to the camcorder via Wi-Fi and use the Browser Remote application to
control the camcorder (
A
162).
U s ing the S upplied Wirele ss Controller
Inserting the Battery
Insert the supplied CR2025 lithium button battery into the wireless
controller before use.
1 Press the tab in the direction of the arrow (
햲
) and pull out the battery
holder (
햳
).
2 Place the lithium button battery with the + side facing up (
햴
).
3 Insert the battery holder (
햵
).
Activating the Wireless Controller
By default, the wireless controller is activated. If it has been deactivated, follow the procedure below to activate
it.
1 Select [WL-D6000].
>
[
B
$
System Setup]
>
[WL-D6000]
2 Select [On] and then press SET.
Using the Wireless Controller to Operate the
Camcorder
When using the wireless controller, point it at the
camcorder’s remote sensor. When the wireless
controller’s buttons are operated, the camcorder’s tally
lamps will illuminate.
NOTES
• When you use the START/STOP button or ZOOM
buttons on the supplied wireless controller, you must
press the record enable button simultaneously with
the desired button.
• When the camcorder cannot be operated with the supplied wireless controller, or when it can only be operated
at very close range, replace the battery.
• The supplied wireless controller may not work properly when the remote sensor is located under strong light
sources or direct sunlight.
Operating modes:
햲
햳
햵
햴