Canon CXDI-50G, Service Manual

Page: 115 / 179

3. Function
8
4
4
A
A
b
b
o
o
u
u
t
t
t
t
h
h
e
e
P
P
o
o
w
w
e
e
r
r
B
B
o
o
x
x
I
I
n
n
i
i
t
t
i
i
a
a
l
l
i
i
z
z
a
a
t
t
i
i
o
o
n
n
S
S
w
w
i
i
t
t
c
c
h
h
Initialization Switch
The LAN can be started with the factory settings when you turn on the power (the main power
of the power box and remote switch) by holding down the initialization switch (see figure
*1
) of
the power box.
The 50G firmware contains the initialization and normal codes.
(They are stored in the PCB-50Di flash ROM)
Normally, the normal code runs on a steady basis, and only normal code is updated when
upgrading the firmware.
Use the initialization code when the normal code cannot start for some reason or when you have
lost the Ethernet settings. Using the initialization code sets the Ethernet-related settings to the
default settings and allows you to perform the startup operation for the initialization code.
In this case, the connection can be made by setting the Ethernet settings in the control PC to the
50G default*
2
.
This default connection allows you to upgrade the firmware again and also check and set the
Ethernet settings again in order to recover the system.
Initialization
*
1
Initialization Switch: Switch 1 mounted on PCB-50 XRY
*
2
Default settings: IP Address=192.168.100.11 ( factory setting )