98
of 148
CALCulate:LIMit:FAULt
DESCRIPTION:
This specifies the comparator's response in the event of a
measurement error.
SYNTAX:
CALCulate:LIMit:FAULt <parameter>
PARAMETERS:
UPPer -> In the event of an error, the comparator indicates that the
measured value is too high.
NONE -> The comparator does not respond in the event of an error.
QUERY FORM:
CALCulate:LIMit:FAULt?
RESPONSE:
UPPER -> If the comparator indicates that the measured value is too
high in the event of an error.
NONE -> If the comparator does not respond in the event of an error.
RESTRICTIONS:
This command is not permissible if a measurement is in progress or
the device is in the calibration mode.
CALCulate:MATH:EXPRession
DESCRIPTION:
This sets the measurement-value display mode.
SYNTAX:
CALCulate:MATH:EXPRession <parameter>
PARAMETERS:
OHM ->
Measured values are displayed in OHM.
DELTa ->
Measured values are displayed as
∆
% of a
setpoint value.
LIMit ->
The evaluation is displayed.
QUERY FORM:
CALCulate:MATH:EXPRession?
RESPONSE:
OHM ->
If the OHM display has been selected.
DELTA ->
If the
∆
% display has been selected.
LIMIT ->
If the evaluation display has been selected.
RESTRICTIONS:
This command is not permissible if a measurement is in progress or
the device is in the calibration mode.
