82
of 148
6.3 SCPI commands
The SCPI commands are displayed in long and short form. The long form contains the entire command,
while the short form consists of the sections indicated in upper case. Command sections enclosed in square
brackets need not be transmitted.
Related parameters are appended with a blank character.
The commands can be entered in upper or lower case, long or short form.
The query form of a command is created by appending a question mark directly to the command.
If a command is sent with a parameter, although no parameter is expected, the Command Warning bit (bit 14)
in the Questionable Status Register is set. The parameter is ignored and no error is indicated.
On the occurrence of an error, the 2329 issues <NAK> instead of <ACK>. The cause of the error can be
determined with the command ":SYSTem:ERRor?" (also described subsequently). In addition , the corresponding
error bits are set in the Status Registers (refer to chapter 6.2.14, Status Register).
The SCPI version can be requested with the command SYSTem:VERSion?.
6.3.1 STATus Subsystem
STATus:OPERation:CONDition? (short form -> S:O:C?)
STATus:OPERation:ENABle
DESCRIPTION:
The Operation Status Condition Register is read out
SYNTAX:
STATus:OPERation:CONDition? or S:O:C?
PARAMETERS:
None
QUERY FORM:
Only query form. The contents of the 16 bit register are returned as a
decimal value
RESTRICTIONS:
None
DESCRIPTION:
The Operation Status Enable Register is set.
SYNTAX:
STATus:OPERation:ENABle <parameter>
PARAMETERS:
Decimal value (value range: 0 to 32767)
QUERY FORM:
STATus:OPERation:ENABle?
The contents of the 16 bit register are
returned as a decimal value.
RESTRICTIONS:
None
