06-56
MMC2005-001_06A.FM
SECTION 06 - DRIVE SYSTEM
INCORRECT
NOTE:
For used drive belt, mark and reinstall in the
same position.
DRIVE BELT HEIGHT
MEASUREMENT AND
ADJUSTMENT
Measurement
NOTE:
The drive belt height measurement must
be performed each time a new drive belt is in-
stalled.
NOTE:
To obtain an accurate drive belt height
measurement, it is suggested to allow a break-in
period of 50 km (30 m).
Before checking the belt height, ensure that a
good-condition proper belt (refer to the
Application
Chart
) is installed.
Adjust pulley distance and alignment. Refer to
PULLEY DISTANCE AND ALIGNMENT.
To obtain maximum vehicle performance, the belt
height must be adjusted according to specifica-
tions shown in the accompanying chart.
1. Flush
Adjustment
Before adjusting the belt height, ensure that a
good-condition proper belt (refer to the
Application
Chart
) is installed.
Adjust pulley distance according to specification,
refer to PULLEY DISTANCE AND ALIGNMENT.
Models Equipped with Formula VSA Type
Driven Pulley
Adjust drive belt height using Allen screws, as
shown.
To lower belt in driven pulley: turn Allen screws
clockwise.
To raise belt in driven pulley: turn Allen screws
counterclockwise.
NOTE:
Turn Allen screws 1/4 turn at a time, then
rotate driven pulley to allow drive belt to settle in
pulley. Check height, repeat as required.
MODEL
BELT HEIGHT
All models
Top edge of drive belt cord should be
flush with driven pulley edge
A01D2LA
1
A02D1UA
Summary of Contents for ski-doo MACH Z 1000 SDI
