BRP ski-doo MACH Z 1000 SDI, Handbook

Page: 303 / 493

SECTION 06 - DRIVE SYSTEM
MMC2005-001_06A.FM
06-41
ASSEMBLY
10, Cam Slider Shoe
When replacing slider shoes, always install a new
set (3 shoes) to maintain equal pressure on the cam.
Install slider shoes as per following photo. RED
slider shoes are being used for reverse and BLACK
ones for forward.
1. BLACK slider shoe
2. RED slider shoe
12, Screws
These screws are machined at there end. With the
adjustment ring steel to position 0 (zero), screw
ends are flush with inner side of fixed pulley half
when tighten.
CAUTION: If any of these screws is not flush with
inner side of sliding pulley, bushings will worn
unequally.
Assemble driven pulley components by reversing
the disassembly procedure.
11, Cam
Coat cam interior with anti-seize lubricant.
INSTALLATION
5, Countershaft
CAUTION: Always apply anti-seize lubricant
(P/N 293 800 070) on the countershaft before fi-
nal pulley installation.
Should installation procedure be required, refer to
BRAKE then look for
BRAKE DISC and COUNTER-
SHAFT BEARING ADJUSTMENT.
Reinstall the pulley on the countershaft by revers-
ing the removal procedure.
Driven pulley end-play is 0 (zero).
1, Pulley Retaining Screw
Torque to 22 N•m (16 lbf•ft).
ADJUSTMENT
Pulley Alignment and Drive Belt Height
Refer to PULLEY DISTANCE AND ALIGNMENT and
DRIVE BELT to perform adjustments.
Loosen screws no. 12 , turn adjustment ring
no. 13 then retighten screws to adjust drive belt
height.
CAUTION: Drive belt and pulley adjustments
must always be checked whenever pulleys have
been removed, replaced or disassembled.
11, Cam
Make sure to install proper cam. Refer to TECHNI-
CAL DATA.
Cam angle is identified on cam.
NOTE: For high altitude regions, a service bulletin
will give information about calibration according to
altitude.
A30D0WA
1
1
2
2
2
1
A30D0XA