SECTION 03 - CHASSIS PREPARATION
MMC2005-001_03A.FM
03-49
1
A32H46A
1
1. Re
m
ove screws
Unplug gauge connector(s).
Pull front console out.
Unplug burnt bulb connector. Re
m
ove the rubber
boot.
T
urn bulb retainer ring counterclockwise to unlock.
Detach the bulb and replace.
A32H44A
CAUTION:
Never touch glass portio
n
of a
n
haloge
n
bulb with bare fi
n
gers, as it short-
e
n
s its operati
n
g life. If by
m
istake glass is
touched, clea
n
it with isopropyl alcohol which
will
n
ot leave a fil
m
o
n
the bulb. After lock-
i
n
g ri
n
g i
n
stallatio
n
, e
n
sure bulb is properly
secured i
n
place.
Properly reinstall re
m
oved parts.
Taillight
If the taillight bulb is burnt, expose the bulb by re-
m
oving red plastic lens.
T
o re
m
ove, unscrew the
2 retaining screws. Verify all lights after replace-
m
ent.
DECAL
T
o re
m
ove a decal; heat old decal with a heat gun
and peel off slowly.
Using isopropyl alcohol, clean the surface and dry
thoroughly.
Apply liquid soap to new decal and carefully po-
sition the decal. Using a sponge or a squeegee,
re
m
ove the air bubbles and surplus water work-
ing fro
m
the center toward the edges. Allow to
air dry.
CAUTION:
Do
n
ot apply isopropyl alcohol or
solve
n
t directly o
n
decals. Use o
n
ly i
n
a well
ve
n
tilated area.
WIND
S
HIELD
Pull windshield one side at a ti
m
e as shown to
re
m
ove it.
A32H48A
Re
m
ove protective fil
m
when installing a new
windshield.
Apply liquid soap on gro
mm
ets prior to installing
windshield to ease pin insertion.
Summary of Contents for ski-doo MACH Z 1000 SDI
