Briggs & Stratton 115400, Manual

Page: 99 / 281

98
5
Fig. 23
9. Whi le removing the carburetor, disconnect
the governor link with anti-backlash spring
(
B ) and the choke link ([ C ] Fig. 23).
10. Remove the two bolts that secure the air
intake manifold to the crankca se
([
A ]Fig.24).
Fig. 24
Installation
1. Make sure the seal is properly seated in
the groove of the air intake manifold ([ A ]
Fig. 25).
Fig. 25
2. Install air intake manifold and torque bolts
to values listed.
3. Slip mounting bolts through carburetor
and connect governor lever with its anti-
backlash spring and the choke link.
4. Slip carburetor gasket on the bolts install
carburetor. Torque bolts to values listed.
5. Place gasket on studs and mount air
cleaner housing on carburet or studs.
Torque nuts to values listed.
6. Install air clean er housing supporting bo lt
(See [ B ] Fig. 22). Torque to values listed.
SEE SECTION 14- ENGINE
SPECIFICATIONS.
7. Install air filter and cover.
8. Install fuel pump to its mounting bracket
(Refer back to Fig. 21). Torque bolts to
values listed.
9. Install hoses and clamps to carburetor fuel
inlet, cylinder housing and fuel tank
supply hose.
10. Install shut-off valve with new hose and
clamps on carburetor fitting. Install screws
and torque to values li sted.