Briggs & Stratton 115400, Manual

Page: 201 / 281

200
10
PTO-Side Ball Bearing
If the measurement obtained from the sump
cover bearing exc eeds limitations:
• Replace sump.
INSTALLING COVERS AND
SUMPS
Seal Protectors (All Models)
Use a seal protector to prevent damage to oil
seals when installing covers or sumps.
Installation: Cylinders and Covers
And Sumps (All Models)
Make sure the mating surfaces of the cylinder
and cover or sump are clean.
1. Place the gasket ([ A ] Fig. 33) on the
mating surface of the cylinder.
Fig. 33
2. Place the cover or sump on top of the
gasket and install the cover mounting
bolts finger tight.
NOTE:
It may be necessary to rotate crankshaft
and camshaft to ge t oil pump (when equipped) to
engage drive slot in camshaft. For counter-
balanced engines, it may be necessary to rotate
the counterweight shaft to mesh with timing gear
when installing cover.
• Do not force cover.
• Make sure mechanical governor gear
and oil pump (if used) is engaged with
camshaft.
• For adjustment procedure for crankshaft
end play, see Page 207.
3. Follow the torque sequence shown for the
engine you are working on:
Tool# Color Size
19334/1 White .787
(19.99mm)
19334/2 Red .875
(22.23mm)
19334 /3 Blue .984
(24.99mm)
19334/4 Orange 1.00
(25.40mm)
19334 /5 Brown 1.062
(26.97mm)
19334/6 Green 1.181
(30.00mm)
19334/7 Yellow 1.378
(35.00mm)
19356/8 Purple 1.317
(33.45mm)
19356 /9 Black 1.503
(38.18mm)