Briggs & Stratton 115400, Manual

Page: 101 / 281

100
5
Fig. 29
The float hinge pin ([ A ] Fig. 30) is a wedge fit.
5. Tap the small end of the pin ( B ) with a
center punch until it is loo se.
6. Remove pin ( A ) and remove the float ([ C ]
Fig. 30) and inlet needle assembly.
Fig. 30
7. Remove pilot jet ( A ) with Screwdriver #
19062
.
8. Pry off the idle mixture valve limiter ( B ), if
used. Remove the idle mixture screw and
spring ([
C ] Fig. 31).
Fig. 31
9. Remove screws ( A ) holding choke pl ate
([ B ] Fig. 32) and remove.
Fig. 32
10. Lift out choke shaft ( A ) with upper ( B )
and lower ([C] Fig. 33) choke shaft
bushings.