Briggs & Stratton 115400, Manual

Page: 78 / 281

77
4
GENERAL INFORMATION
To meet the various requirements of the original
equipment manufacturers (OEMs), some
engines are shipped without exhaust systems.
Exhaust systems for these engines are serviced
and supplied by the OEM. Contact the original
equipm ent manufacturer for speci fic service
information on non-Briggs & Stratton exhaust
systems.
CAUTION:
When replacing exhaust system
components, replacement parts must be the
same as originally specified by the OEM. This
may include some mounting brackets and
hardware. Follow the procedures recommended
by the OEM for disassembly and assembly.
Inspecting Exhaust Systems
General
Exhaust system components must be inspected
whenever the exhaust system is disassembled.
Never reinstall broken or damaged components.
Check for:
• Cracks
• Broken welds
• Split muffler seams
• Loose internal parts
• Gaskets
• General wear and fit
Inspect the exh aust manifold for damage and
signs of leakage at the cylinder and muffler
mating surfaces.
Spark Arrestors
Remove spark arrester ([ A ] Fig. 1) for cleaning
and insp ection monthly or every 50 hours.
Replace screen if deteriorated or perforated.
Fig. 1
DANGER
Running engines produce heat.
Temperature of muffler and surrounding
areas can reach 150°F (65°C). Severe burns
can occur on contact.
•
Allow muffler, engine cylinder finds and
radiator to cool before touching.
•
Remove accumulated combustibles
from muffler area and cylind er area.
•
Install and maintain in working order a
spark arrestor before using equipment
on forest-covered, brush-covered
unimproved land. The state of
California requires this (Section 4442
of the Public Resources Code). Other
states may have similar laws. Federal
laws apply on federal land.