Briggs & Stratton 115400, Manual

Page: 55 / 281

54
2
• Check the ignition switch ([ H ] Fig. 51).
Fig. 51
Troubleshooting Oil Gard® 4 -Wire System
NOTE: (185430, Type 0099-1)
These
engines are wired with compon ents supplied by
both Briggs & Stratton and the OEM. Contact the
OEM for wiring diagrams an d service
information.
Symptom: Engine starts, dies, and will not
stay running
• Disconnect BLUE or BLACK wire at ([ A ]
Fig. 52) an d start engine.
If the engine starts and dies:
• Replace the module ( E ) and retest.
If the engine starts and runs:
• Reconnect the wire at ( A ).
If the engine d ies:
• Check continuity in the wire between ( A )
and ( B ).
If there is no continuity:
• Replace the wire.
If the wire is go od:
• Replace the float sensor in the cylinder
([ F ] Fig. 52).
Symptom: Engine will no t start
• Disconnect wire at ([ C and D ] Fig. 52)
and start engine.
If the engine does not start:
• Check the ignition armature ( G ) for
grounds.
If the engine starts and runs:
• Reconnect the wire at ( C ).
If the engine does not stop:
• Reconnect the wire at ( D ).
If the engine d ies:
• Check the
ON/OFF
rocker switch ([ H ] Fig.
52).
Fig. 52