Briggs & Stratton 115400, Manual

Page: 53 / 281

52
2
Fig. 47
Fig. 48
NOTE: (104700 ) The pressure switch may
activate at engine speeds below 2000 RPM,
which is normal.
If the switch does not deactivate at speeds
above 2000 RPM:
• Stop the engine and check for proper oil
level.
• Perform an oil pressure and/or oil
pressure switch test.
Oil Pressure Switch Test
Set meter. See Figure 8.
1. Remove the switch.
2. Connect one tester lead to the switch
terminal and the other tester lead to the
metal body of the switch, Fig. 49.
Fig. 49
There should be continuity when no pressure is
applied to the switch.
3. Connect the probe end of the switch to a
low pressu re source ([ A ] Fig. 49).
The switch should open at approximately:
•
104700
- 4 to 6 psi (0.28 - 0.41 bar)
•
260700, 261700
- 7 to 10 psi (0.48 - 0.69
bar)
•
28Q700
- 7 to 10 psi (0.48 - 0.69 bar)
4. Replace the switch if test results are not to
specification. Torque to listed value .
5. Start engine and check for oil leaks.
Oil Pressure Test
If the oil pressure switch is within specifica tion
and the warning light remains on, verify engine
oil pressure with an oil pressure gauge ([ A ] Fig.
50) .
Fig. 50