BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual, Page: 387 / 427

Section 08 STEERING/FRONT SUSPENSION
Subsection 02 (STEERING SYSTEM)
MMR2004-140_08_02A.FM
08-02-9
Check if handlebar is horizontal. To adjust, loosen
lock nuts of short tie rod and turn it accordingly.
1. Pivot arm centered in slot
2. Slot
3. Turn to adjust
A. 20 mm (25/32 in) maximum
Restrain short tie rod while torquing nuts so that
ball joint sockets run parallel with steering arm and
pivot arm.
Ensure that pivot arm is still centered and check
ski toe-out.
TOE-OUT ADJUSTMENT
Raise front of vehicle so that skis are off the ground.
Loosen lock nuts of long tie rods and turn each tie
rod so that skis are in a straight ahead position. To
adjust toe-out, slightly turn both tie rods exactly
the same amount.
Make sure external threaded length not engaged
is not too long and torque nuts as specified above.
LONG TIE ROD SHOWN
1. Restrain tie rod to tighten lock nuts
LONG TIE ROD SHOWN
1. Ball joint parallel with arm

WARNING
Maximum ball joint external threaded length
not engaged in the tie rod end must not exceed
20 mm (25/32 in). Torque lock nut to 18 N•m
(159 lbf•
in ).
3
A05G0KA
1
2
A02G0SA
A
A

WARNING
Ball joint sockets must run parallel with steering
arm and pivot arm. Tie rod must be restrained
when tightening lock nuts.
A05G08A
1
A05G09B
1